Eagle H-Beam Connecting Rod 5.967 in Length, Single Rod for Honda B18 (B18A/B)
Eagle's forged 4340 H-beam connecting rod gives the Honda B18 (B18A/B) a 5.967 in length, sold as a single rod. It suits competition builds that need extra rod length or a replacement for one rod in a set. Eagle recommends its H-beam rods for competition engines, including forced induction and nitrous.
Key features
- Forged 4340 steel: Eagle forges its H-beam rods from 4340 steel for strength under load.
- Two-piece forging: the beam and cap are forged separately, and the cap is forged perpendicular to the beam to help the big-end bore hold its size under load.
- Machined and shot-peened: the surface is fully machined and shot-peened to remove surface inclusions, which is where fatigue cracks start.
- Bushed for full-floating pins: Eagle bushes its H-beam rods for full-floating piston pins and uses alignment sleeves to locate the cap.
- Sized to tight tolerances: if weight matters for your build, specify the weight you need when you order.
Specifications
| Brand | Eagle |
|---|---|
| Part number | CRS5967A3D-1 |
| Engine | Honda B18 |
| Material | Forged 4340 steel |
| Beam type | H-beam |
| Rod length | 5.967 in |
| Quantity | Single rod |
Forged rods only go as far as the block holding them. For a B18 build, an EPOXY54 kit for the B18 gives the block closed-deck strength without machining and installs DIY in 5 steps.
Fitment
Fits Honda B18. Match by part number CRS5967A3D-1 before ordering.
WARNING: This product can expose you to chemicals known to the State of California to cause cancer and/or reproductive harm. For more information, go to www.P65Warnings.ca.gov.
